*BALANCED INPUT JACK
The balanced XLR input jack allows the AN-1000X to be used in a va-
riety of applications. The input can be user configured for a Lo-Z mi-
crophone or bridging balanced line-level inputs (such as used in the
pro-audio and broadcast industry). In addition, the input has 15 volt
phantom power which may be switched on or off.
The factory default setting is for microphone-level inputs w/ 15 volts DC
phantom power. Follow the instructions below to change settings.
Change Balanced Input Jack Configuration
1. Remove rubber grommet located just above XLR input
2. Set the three dip switches w/ a small pointed object
3. Replace rubber grommet to protect system
BASIC SYSTEM OPERATION
The AN-1000X is the most versatile powered monitor on the mar-
ket, is designed to amplify the signal from a wide variety of input
sources. Use it on an A/V rack, as a studio monitor, in a trade show
booth or on a US Navy warship, you decide.
Here’s How Easy It Is To Use
1. Place the AN-1000X in desired location
2. Plug the power cord into a grounded AC outlet
3. Plug an audio source into one of the three input
jacks on the back panel:
• LINE IN - RCA jack
• LINE IN - 1/4-inch phone jack
• BALANCED INPUT* - XLR jack
4. Turn volume control on front panel to minimum
5. Set power switch on back panel to ON
(red LED on front panel should light)
5. Adjust the volume, bass & treble controls to desired levels
IMPORTANT: To avoid feedback, do not position
a microphone in front of speaker.
SPEAKER OUT
The external speaker output jack (1/4”-phone,
unswitched) allows the user to power an auxiliary
unpowered speaker (such as the AN-1001X). Min-
imum 8 ohms impedance for auxiliary speakers.
AN-1000X
CONTROL PANEL
POWER SWITCH
AC POWER CORD RECEPTACLE
CAUTION: ALWAYS use shielded audio cables on input connections to prevent interference.
PROBLEMS? Consult the troubleshooting section on the back page of this manual.
NEED MORE HELP? Contact the Anchor Audio Customer Service Department - 888-444-6077.
54
LINE OUT
The line-level output provides a replica of the
composite input signal. Use it for direct recording
or to daisy-chain additional powered sound sys-
tems to the AN-1000X for greater crowd coverage.
LINE IN
The line-level inputs
(RCA & 1/4” phone)
are used with input
sources such as VCR’s,
CD players, musical
instruments, computers,
mixing consoles, etc.
Both inputs can be used
simultaneously w/ the
AN-1000X volume knob
controling composite
program output.
BALANCED INPUT
The balanced XLR input jack can be user configured for a Lo-Z
microphone or bridging balanced line-level inputs. In addition
it has 15 volt phantom power which can be switched on or off.
RUBBER GROMMET
DIP Switch Option Settings
(5 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels